Wednesday, May 15, 2013
How to Replace an Allroad Headlight
1. Park your Audi on a flat, level surface and turn off the engine. Let the car sit for 10 minutes to cool before popping the hood and securing it with the prop bar.
2. Go to the rear of the headlight assembly and locate the two T25 screws along the top of the headlight. Use your torx wrench to remove these screws. Be sure to place them somewhere safe so that they do not roll away during this procedure.
3. Fit your wrench with an extension. Locate and loosen the screws on either side. Do not completely remove these screws.
4. Slide the Allroad headlights out a few inches until you can access the wiring harness. Remove any clips and unplug the wires from the headlight assembly, then slide the headlight completely free.
5. Reverse the previous steps to install the new Allroad headlight into your Audi. Reattach the wires, clip them in place. Slide the headlight in to the headlight cavity. Tighten the side screws and insert the top screws. Close the hood.
